Mitel SIP USER AND ADMINISTRATOR GUIDE 5320 Especificaciones Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 61
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
5320 SIP Phone SIP User and Administrator Guide
- 49 -
Handset Alerting Tones and LEDs
The handset provides the following alerting tones:
Feature Function
Mute key on cordless device
ON/OFF
2-pitch tone occurs immediately. Reminder tone occurs 30 seconds
after activation and then regularly until deactivated.
Mute key on Phone ON/OFF
No immediate tone with DECT. Reminder tone occurs 30 seconds
after activation and then regularly until deactivated.
Low battery (within 10 minutes left
for DECT)
3 beeps and 20 second pause repeated 3 times
Low battery (within 2 minutes left) 3 rapid beeps and 1.5 second pause repeated 3 times
Out of range Repetitive 3-pitch tone until you are back in range.
Note
: If you are out of range for more than 10 seconds, any call that is
in progress is dropped and not recovered.
Note: Audio indications are heard in the handset only when it is in use and may interrupt voice
transmission.
The handset has two LEDs:
Blue indicates the operational status of the handset
Green indicates the status of the electrical charge of the battery
LED Color LED State Indicates
Blue Solid Handset is muted
Blinking Handset is in pairing mode
Winking Active audio path between Handset and Module
Off No audio path between Handset and Module OR
Battery is dead
Green Solid Battery is fully charged
Blinking
Battery is charging. Note: It is normal for the handset LED to cycle between
blinking and solid as battery charge is maintained.
Off
When handset is cradled and the LED does not flash or illuminate, this indicates
an absence of battery power. During the first 30 60 minutes that the light is
off, the battery may be trickle charging. If that is the case, the LED will resume
normal behavior within that 60 minute period. If the LED remains off for more
than 60 minutes, then either the battery is no longer chargeable or there is a
problem in the charging circuit.
Blinking: LED is On and Off for equal amount of time
Winking: LED is On for a short period of time and Off for a longer period
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 61

Comentarios a estos manuales

Sin comentarios