Mitel 300 Manual de usuario descargar pdf (Pagina 7)

The handset should now be registered, and should display the assigned identity. If it is not registered, wait

ten seconds and then repeat the above steps.

Manually Registering the 5020/5040 Handsets

To manually register the 5020/5040 handsets to the KWS300, follow these steps:

1. Insert the battery, plug in the charger, and place the handset in the charger for four hours.

2. Press the left soft key to turn on the handset.

3. Press Menu to enter the main menu.

4. Scroll to Settings and press Select.

5. Scroll to Advanced and press Select.

6. Scroll to Login and press Select.

7. Scroll to Create login and press Select. The handset will start searching for a system.

8. Scroll to the found system and press Select.

9. On the AC code screen, press Ok to connect to the system.

10. Press Ok.

The handset should now be registered, and should display the assigned identity. If it is not registered, wait

ten seconds and then repeat the above steps.

Testing the Configuration

To ensure that the KWS300 and handsets are correctly configured, you must run the following tests.

1. Call to voice mail

Place a call to the voice mail access number and set the voice mail password for that user.

2. Internal Call – hard phone/soft phone

Place a call to user with a hard phone or soft phone. Make sure there is two-way audio.

3. Internal Call – Handset to Handset

Place a call to another user with a KWS handset. Make sure there is two-way audio.

4. External Call to PSTN number

Place a call to a PSTN number through a gateway. Make sure there is two-way audio.

Troubleshooting

1. The phone freezes

Remove and replace the battery pack. Turn on the telephone.

1 2 3 4 5 6 7 8 9

Sin comentarios

Mitel 300 Manual de usuario Pagina 7