3
Preparation
The following sections provide instructions regarding how to change the KWS3000’s factory IP address
setting and how to apply firmware updates.
PC Network Settings
The KWS300’s are configured by default with a static IP address of 192.168.0.1. In the event that this IP
address conflicts with other IP addresses in your local network, or that this IP address is not in the same
subnet as your network, then you must change the Wireless Server’s IP address. However, to access the
KWS300 and change its IP address, you must change your PC’s IP address to be on the same subnet.
NOTE: Make a note of your original network settings before making any changes because you must
change these settings back after changing the network configuration on the Wireless Server.
To change the IP address of your computer for Windows Server 2008/Windows Vista, follow these steps:
1. Select Windows Start > Control Panel.
2. If you have the classic view, double-click Network and Sharing Center and then select Manage
Network Connections.
If you have the category view, double-click Network and Internet > View network status and
tasks and then Manage Network Connections.
3. Double-click the active LAN or Internet connection.
4. Select Properties.
5. In the Networking tab, highlight the Internet Protocol (TCP/IP) item, and select Properties.
6. In the General tab, select Use the following IP address, and enter:
IP address: 192.168.0.2
Subnet mask: 255.255.255.0
7. Select OK.
To change the IP address of your computer for Windows Server 2003/Windows XP, follow these steps:
1. Select Windows Start > Control Panel.
2. If you have the classic view, double-click Network Connections.
If you have the category view, double-click Network and Internet Connections, and then select
Network Connections.
3. Double-click your active LAN or Internet connection.
4. Select Properties.
5. In the General tab, highlight the Internet Protocol (TCP/IP) item, and select Properties.
6. In the General tab, select Use the following IP address, and enter:
IP address: 192.168.0.2
Subnet mask: 255.255.255.0
7. Select OK.
Changing the IP Address of the KWS300
New (or factory reset) KWS300 are configured with a static IP address. This must be changed so that the
device can communicate on your network.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales